Revision as of 01:18, 22 August 2009 ddgonzal (Talk | contribs) <- Previous diff |
Revision as of 01:55, 22 August 2009 ddgonzal (Talk | contribs) Next diff -> |
||
Line 5: | Line 5: | ||
= Choke Cable Adjustment = | = Choke Cable Adjustment = | ||
- | = Float Level Check = | + | = Float Level Verification Check = |
+ | To check the float level, attach a sight glass to the drain plug. | ||
+ | |||
# Remove drain plug. Catch gasoline in a cup. | # Remove drain plug. Catch gasoline in a cup. | ||
# Take a 5/16" hose L-fitting. Fit clear 30mm plastic tubing pointing up, and jam the fitting into the drain hole. Make sure it is secure. Position it parallel to the bowl (straight up/down). | # Take a 5/16" hose L-fitting. Fit clear 30mm plastic tubing pointing up, and jam the fitting into the drain hole. Make sure it is secure. Position it parallel to the bowl (straight up/down). | ||
+ | #: Nissan had a tool for this, number ST19200000 "Float level gauge" | ||
# Start the engine and let it idle. | # Start the engine and let it idle. | ||
# Measure the level of fuel in the tube | # Measure the level of fuel in the tube | ||
#* 22-24 mm from fuel bowl gasket | #* 22-24 mm from fuel bowl gasket | ||
#* Adjust float if too high or too low | #* Adjust float if too high or too low | ||
+ | |||
+ | = Float Level Static Adjustment = | ||
+ | When replacing the float level needle and seat, set the static level of the float. | ||
+ | |||
+ | [http://datsun1200.com/modules/myalbum/photo.php?lid=20170 http://datsun1200.com/uploads/photos/20170.jpg] | ||
+ | |||
+ | # Remove Float Chamber cover | ||
+ | # Place it upside down and level | ||
+ | # Level from top of brass lever to flange (without gasket) should be: | ||
+ | #: 11-12 mm | ||
+ | # If needed, adjust lever by carefully (and slightly) bending inner tab of brass lever. | ||
= Piston Lift Check = | = Piston Lift Check = |
Revision as of 01:55, 22 August 2009
Contents |
Idle Mixture
Choke Cable Adjustment
Float Level Verification Check
To check the float level, attach a sight glass to the drain plug.
- Remove drain plug. Catch gasoline in a cup.
- Take a 5/16" hose L-fitting. Fit clear 30mm plastic tubing pointing up, and jam the fitting into the drain hole. Make sure it is secure. Position it parallel to the bowl (straight up/down).
- Nissan had a tool for this, number ST19200000 "Float level gauge"
- Start the engine and let it idle.
- Measure the level of fuel in the tube
- 22-24 mm from fuel bowl gasket
- Adjust float if too high or too low
Float Level Static Adjustment
When replacing the float level needle and seat, set the static level of the float.
- Remove Float Chamber cover
- Place it upside down and level
- Level from top of brass lever to flange (without gasket) should be:
- 11-12 mm
- If needed, adjust lever by carefully (and slightly) bending inner tab of brass lever.