| Black drag race 1200 #2
 tens_and_twenties  Drag  2002/8/13 3:42  Tell a friend
 4740  0  8.50 (2 votes)
| Here's the same car lining up to run. |
|
| Black drag race 1200 #1
tens_and_twenties Drag 2002/8/13 3:39 Tell a friend
6781 0  6.50 (2 votes)
| This car was spotted at the NHRA Sport Compact Nationals. The driver was crippled and had hand controls for everything! |
|
| A Series Turbo
go_the_datto Engine 2002/8/12 13:10 Tell a friend
23101 6 7.00 (2 votes)
Here is my manifold nearily finished.
Next step is to box the carby in.... |
|
| Pitroad A15
ang94541 Engine 2002/8/11 8:30 Tell a friend
13374 15  0.00 (0 votes)
| This 1,000,000 yen A15 translates into $8,327.78 US. |
|
| inj fwd a-12
1200rallycar Engine 2002/8/11 7:42 Tell a friend
12258 2 9.00 (1 vote)
| an injected front wheel drive a-12 from one of these japaneese race car sites that everyone wants to translate :) |
|
| Pertronix Ignitor #1741
ang94541 ang94541 2002/8/5 18:25 Tell a friend
13437 10  8.00 (2 votes)
Im sure this is not the hottest setup for the distributor, but its way better than points. It installs in place of the points. A plastic collar with 4 magnets slips over the distributor shaft, under the rotor. Red wire to +12V at ballast resistor, Blk wire to -side of coil.
I've never had a problem, but I use to keep a set of points in the car just in case. |
|
| Another radiator/electric fan view
ang94541 ang94541 2002/8/4 19:51 Tell a friend
5308 5 7.50 (2 votes)
| I knew i had another pic. This shows the clearance between the fan and pulley a little better. On the lower left side of the radiator is the electronic thermostat for the fan. It has a probe that pushes inbetween the radiator fins to detect water temp. |
|
| A series turbo
go_the_datto Forum 2002/8/4 9:53 Tell a friend
4907 3 0.00 (0 votes)
Here is an A12 piston that has had a hard life.
The turbo set up was not well designed ie no intercooler and exhaust running beside the carby. But it lasted for about 5 months and was still (just) running when I pulled it down. Check out the size difference in the other piston its out of a 460 ford |
|
| Dattodudes New GT28..Mmm
dattodude Engine 2002/8/3 13:09 Tell a friend
10218 4 0.00 (0 votes)
I got my new turbo today. It needs a 26mm spacer to fit on the standard manifold.
I'm making my own manifold now  |
|
| No1200 front
NO1200 Body and Interiors 2002/8/3 6:36 Tell a friend
10127 2 0.00 (0 votes)
|
