If I were going to do a mid mount with a Holinger box I would use the RD6 Sequential box. (V8 Supercar, Dodge Viper etc) They do a transfer housing and a slip yoke housing and have heaps of different ratios available.from a 6 speed with 6th @1:1. A 6 speed single overdrive and a 6 speed double overdrive. Also a 5 speed is available with a single overdrive. Not to mention the fact that they are rated to 800NM of torque! The transfer housing can be mated to their Alloy nine inch housing and adaptors can be made to suit just about anything. As the Quill shaft (Inptu shaft) is seperate you can make one to suit any didtance you require.



Although one of these boxes will set you back around $19K or if you know someone around $17K and you can set up a remote shift from the back, top or both. One Bad Mother FLIcker

Midmount datsun with a turbo qr20de, no need for this box just use the nissan fwd a-la-Zcars mini, simple H pattern, silky smooth synchros and the whole setup will cost a third of what this box costs.

Nice for a gt40 replica or original but prob cost same as the replica gt

Lets just say that if you had the casings and the electronic controller and you paid cash for the sequential conversion then you would no longer have your 10% deposit for a house.

dont like paddle shift..I have driven a few cars with them now and they basically suck..give me a sequential manual shifter anyday like the WRC cars and BTCC cars and also the Z-Cars Minis!!!

Ironically that is what this box usually runs but some people just can't have enough buttons. Mabey it was sent o GWBush!