|
|
| Re: [EOI] - Flex-Form Composite Leaf Springs Group Buy |
Subject: Re: [EOI] - Flex-Form Composite Leaf Springs Group Buy
by NIS2000 on 2013/3/6 22:57:46
Also should have said measurment was taken from wheel arch center to ground, so some tyre compression was also included in droop figure. This would bump rate up further at that ROUGH 22mm figure if tyre compression was subtracted. All i'm saying is the spring rate is very close to quoted Nissan spec, as you would expect given it is a standard pack, my experience with loading know 500kg loads in tray(over loaded with additional passengers) in past and where springs sit with that known load. Of course if want accurate results you could do a complex lengthy mathematical theoretical equation, order a new pack and put it in a test rig if you don't trust the nissan figure, whats the point? Your not going too get everyone to agree on ride height preference or spring rate they want in a custom composite monoleaf anyway. I would not enter into a group buy like this for that very reason and for same reason i'm not spending my time doing accurate measurements to prove you wrong. I was just trying to assist with a bit of basic info and ROUGH measurments that took 5minutes of my time.
|
|
