|
Re: Silvia brakes on 1200 struts | Subject: Re: Silvia brakes on 1200 struts by ANGE on 2013/8/18 13:37:21
ddiesel is right, next time you have a rotor in your hand you'll see that while you could just machine the "cone" of the hub enough to accept the rotor, if you leave a chamfer on the base of the "cone" it will spigot the center bore of the rotor locating it nicely rather than just leaving that job up to the wheel studs.
the o.d of the hub also needs machining but again that is very minimal
if i still had the ute i'd take some pics and it would be much easier to explain (pics say 1000 words)
|
|