|
|
| Re: Indicator contacts and adding relay/s |
Subject: Re: Indicator contacts and adding relay/s
by ddgonzal on 2025/1/17 0:05:39
None of my 1200 indicator switches ever suffered from burnt contacts, even after 40+ years of use ... so a relay is unnecessary
Note that if the contact points are cleaned/filed with a ferrous type sandpaper, they may foul again.
TIPS:
* use a points file
* or a stone
* or paper
* Make sure there is no oil or grease on the points
I think there is no condenser in the indicator wiring circuit, however the ignition system uses one: at the distributor (normally replace every time the distributor points are replaced)
The only problem i encountered was they would short occasionally, necessitating a removal and reinstallation and replaced of the fuse. This was due to the switch becoming loose. Solution: ensure the switch screw is tight enough. Specifically, these screws
|
|
![Open in new window](javascript:CaricaFoto("http://datsun1200.com/uploads/photos/24404.jpg");)
![Open in new window](javascript:CaricaFoto("http://datsun1200.com/uploads/photos/19645.jpg");)
![Open in new window](javascript:CaricaFoto("http://datsun1200.com/uploads/photos/19662.jpg");)