|
|
| Re: -ve camber on a 1200 |
Subject: Re: -ve camber on a 1200
by rgrinder on 2002/9/12 5:55:52
should work, but it would work better if you were to slot the holes and then use eccentric bolts for adjustment. they are those funny looking bolts that have flat washers welded to then off center. that way when you tighten them up the large flat washer on them helps hold everything tight. IF you are still confused about it go to a front end shop and ask them to show you what they look like.
as an alternitive, why not just put in a longer lower control arm? as I recall the 79-82 B310 ones will work and are about 10mm longer.
|
|
