|
|
| Re: Q: 120Y Disc conversion for 1200 ute??? |
Subject: Re: Q: 120Y Disc conversion for 1200 ute???
by bcg on 2005/10/27 12:30:15
Cheers!
Thats very clear. In any case, I'll make sure I document the process step by step to add something back to this site.
Yep - I made sure I grabbed the sway bar. I took the master cylinder, struts and front lines.
At the moment, there appears to be a twin master cylinder in it with only the rear pot connected to a line which then goes to a distribution block that feeds all of the brake lines. Was this an original, quasi-twin circuit system? Or has someone replaced the master cylinder at some point? The master cylinder has two, same sized pots on it.
|
|
