|
|
| Re: brake swapping |
Subject: Re: brake swapping
by Chassis_slappin_1200 on 2006/12/21 0:36:50
####. the rotors wont fit in my lathe by about 1 to 1.5 mm. ahhhh. I have to take them to an engineering shop now and pay out my arse for a 5 minute machining job that any idiot (including me) could do.
PIGDOG with that rowley disk conversion he hasnt used the original datto mounting point for the new disk. He has moidified the hub so the disk just slips over the studs(longer than standard I presume, I was thinking of doin it this way but it will space my wheels out around 6-7mm using the original datto hub.
I am looking at bolting the silvia disk to the back of the hub and making an adaptor plate for the caliper to suit.
|
|
