|
|
| Re: IRS Ute Conversion |
Subject: Re: IRS Ute Conversion
by micksute on 2009/3/2 21:29:43
You might already know this, but if you grab some 300zx turbo driveshafts you can machine them to fit. All other Nissan driveshafts (that I know of...but suspect GTR are the same) are going to be milled down at the point you will want to machine and too narrow as a result.
You chopped the irs a different way to me slightly and I built up the mounting point slightly from the chassis rail and added some support....but how low you go, wheels, suspension travel etc will dictate this of course.
Looking good so far!
|
|
