|
Re: CNC engine idea final | Subject: Re: CNC engine idea final by Datsun100ATurbo on 2011/4/17 16:27:50
My friend with the speedshop planned to cast a new block for their Volvo because they had huge problems with the standard block holding up the 500hp/l. He even made a mould for the new block but the casting was to expensive here in Finland and he had to order atleast 50 pieces!? Don´t want to be a pessimist, you have a great idea there!!
Marcus
Quote: D wrote: Very clear thanks for the info. Casting would be the only way to go. Ive measured the zx14 head and almost all fits withing the ca18de block. It would be easier and cheaper to slice a ca18de bottom end, remove the cylinder casing area and shape the left over to suit the kawa top end. This will allow the use of the ca18de crank, oil pump / filter, alternator mount, engine mounts and the rear could have material removed and still have room for a plate to mount to t5 gearbox.
|
|