|
|
| Re: CNC engine idea final |
Subject: Re: CNC engine idea final
by D on 2011/4/16 13:24:10
Very clear thanks for the info. Casting would be the only way to go.
Ive measured the zx14 head and almost all fits withing the ca18de block.
It would be easier and cheaper to slice a ca18de bottom end, remove the
cylinder casing area and shape the left over to suit the kawa top end.
This will allow the use of the ca18de crank, oil pump / filter, alternator
mount, engine mounts and the rear could have material removed and still
have room for a plate to mount to t5 gearbox.
|
|
