|
Re: CNC engine idea final | Subject: Re: CNC engine idea final by D on 2011/4/18 0:52:10
That blows casting out or the picture, unless i go into the homecasting forums and find someone interested in doing low run sand casting.
I still think high quality flat alloy plate at around an 30mm in thickness wont suffer much warping if welded.
Since the cylinder sleeves are separate there is more emphasis on the oil lines, oil pump area, engine mount area and line boring.
--- About the volvo block, I didnt know that some later blocks? suffered over 500hp The early pushrod blocks and first ohc ones are massively over engineered. Are you talking about the later modular alloy ones?
|
|