|
Re: A12iR Project (i = single point injection, R = supercharged) | Subject: Re: A12iR Project (i = single point injection, R = supercharged) by racer135 on 2018/4/20 1:42:54
Haven't done anything on it in 2 or 3 years.
Now has gilmer pulleys from Kemotorsport in Adelaide.
I bought a new pair of injectors from CAPA Performance which are from the supercharged V6 (L67?) VT commodore, correct cc's with a little headroom according to the online calculator I used. Can't remember if the spray pattern is correct though.
Got an SR CAS modified to take an A-series gear and fit the hole. But after all that got done I realised the shaft has helical grooves in it which keep the oil out of the top section of the sensor. Too much money and messing about to make a new shaft with grooves in it the correct direction for the direction of rotation of the A-series (opposite direction of the SR). Instead I'll gut an A-series dizzy and make a 4 tooth trigger wheel to fit inside with a CAS inside or outside, and make an adapter for the crank to bolt a trigger wheel and the gilmer pulley to.
|
|