|
|
| piston to valve clearance |
Subject: piston to valve clearance
by LoserMachine on 2014/5/20 4:39:12
hello, i put L16 valve in my h10 head 38\33. I've checked the inlet valve to cylinder wall clearance and its good. the exhaust needs opening though(about 1.5 mm wider).
now i also have a .423" lift cam i was trying to figure out if this could clear with stock dish .040" over pistons, to do so i need to find out what the stock piston to valve clearance is, dose anybody know? also how far dose the exhaust valve protrude into the block deck so i know what depth to cut out of the stock valve reliefs?
|
|
