|
|
| Re: Turbo EFI A12 for under $1200. Discussion thread |
Subject: Re: Turbo EFI A12 for under $1200. Discussion thread
by lamb_daiquiri on 2016/7/28 22:13:45
Endfab: I'm using 25NB sch40 steam pipe and butt weld fitting if that helps. It's a good match for the exhaust port size which you want to maintain to the turbo inlet, at this point the cross section reduces further to convert the pressure in the exhaust to velocity, which is how the power is extracted in the turbine. You want to avoid any expansions before the turbo as these waste energy.
|
|
