User Login    
 + Register
  • Main navigation
Login
Username:

Password:


Lost Password?

Register now!
Fast Search
Slow Search
Google Ad


Report message:*
 

Re: Removing 1200 rotors from hubs

Subject: Re: Removing 1200 rotors from hubs
by ddiesel on 2015/11/12 11:28:45

If it's all apart as you say then get 2 house bricks and place them on concrete end up. Place the disc/hub between the bricks wheel face down with the rotor face on the bricks. Using a hammer strike the inner wheel bearing seal carrier area lightly moving around its full circumference. This should loosen the joint. A press is certainly not required as the joint is not an interference fit.