|
Re: Identifying gears and synchronizer hubs for FS5W60A | Subject: Re: Identifying gears and synchronizer hubs for FS5W60A by TexasMidget on 2016/7/21 5:13:11
DD, I see that you posted some of the pictures and measurements on Tech Wiki. Good idea to use the OD on the shaft for reference. Much more accurate than the needle bearing cage measurements. Attached is 1st gear. I can get reverse tomorrow. Busy with my motor as well. Just picked up my A15 block from another shop. They had to clean up the poor machining that was recently done. Block had to be decked and I got my 45 degree cross hatch. Will post pics on that later this week.
|
|