|
|
| Re: CA16 pistons and maybe rods?? |
Subject: Re: CA16 pistons and maybe rods??
by dvr1000 on 2017/5/19 5:43:51
I've thought the same. I have a set of ca16de pistons. The raised tops may have to be machined with flycuts for the valves and matched to the chambers. The pins suit fully floating conversion of the rods. Nice pistons with drilled rather than slotted oil returns = stronger for higher revs. Need a bit of calculation for the compression ratios. I think they might be the same piston fitted to the 2 litre RB motors.
The rods also look like they'll fit and they're much beefier that the a15 rods.
|
|
