|
|
| Clutch problem....... |
Subject: Clutch problem.......
by Daves-1200 on 2017/7/13 6:45:23
Hey guys,
I hope all is well with you Datsun fans!
Well after saving and many items have been purchased so I am finally getting the work underway on my 72 Datsun B110 build.
BUT.....I am having a bit of a nightmare with the clutch!
I have a mint Datsun A14 engine that I am turbocharging and have all the engine bits to do this and this build has been proven to put out 350hp but we are tuning it to 250hp with a rolling high boost of 300hp - so it would be wise to rate the Clutch to 350hp.
The gearbox I am using on this car is a Toyota 3T and we are in need of a clutch to use for this application of A14 to 3T through a Dellow bellhousing kit.
The current clutch/pressure plate set up is 180mm for the totally standard A14.
The 7.25'' Tilton clutch has been suggested and with your collective experience will this work and be able to cope with the power and what modification is required to the existing flywheel?
Do you guys have any suggestions of any other clutch kits that will work to a power level of upto 350hp?
I want the clutch to be as road friendly as possible - naturally.
I will look forward to hearing from you all.
Take care
Dave in the UK!
|
|
