|
Re: Miata crank in A-series block? | Subject: Re: Miata crank in A-series block? by D on 2017/11/30 13:04:03
Id say its quite possible since ford crossflow ohv guys use the L18 and L20b crankshaft machined down to suit the ford bearings. Lemonhead I think used an e16 crank with a sleeved A14/A15 block, either E series rods or custom with 82.5mm bores which his engine machining guy said could go to 83mm bores reaching 1905cc.
|
|