|
|
| Re: A15 Rebuild Progress |
Subject: Re: A15 Rebuild Progress
by TexasMidget on 2018/4/12 4:48:42
So on one of my other threads I mention I am on the top end of tolerances for ring gaps on the top and 2nd ring. Engine was honed out only. I question if honing is the right way to go on a motor that had 150000+ miles. To do this rebuild right should I go for an overbore and get everything within proper tolerance? Found a set of AE pistons .020". Vendor claims they are from Japan. Is this a good brand of pistons?
|
|
