|
Re: Cowl Rubber around wiper pivot | Subject: Re: Cowl Rubber around wiper pivot by DatPilot on 2018/11/17 12:01:55
Sorry I haven't got a picture right now
But to try explain
They are a cylinder type shape, probably about 2mm thick wall Perhaps 32-35mm diameter
The bottom end is cut square with the cylinder shape and a small notch cut out to sit over one of the nuts for wiper pivot bolt
The top side that goes to underside of cowl, is cut on an angle to the cylinder To match the profile of cowl
I'm thinking I might have to make my own with some suitable sized black rubber tubing and a razor blade
|
|