|
Re: Wanted - 1 x used standard A15 piston (sample for forging supplier) | Subject: Re: Wanted - 1 x used standard A15 piston (sample for forging supplier) by D on 2019/1/21 3:01:51
Do you need to re-sleeve your block which A series is it? The quote i got 5 years ago was from Footscray engine reco spoke to George who seemed the nicer one vs the gay bikie. Had 2 a12s bore and honed there on for stock slugs the other for A15 pistons for the sneaky A14/A12 1361cc stroker.
Both were early block with dizzie at the front for easy rego. Also had my crankshaft balanced after using my angle grinder to clear counterweights to fit A12 pan and rods suit a15 pins. There are prob some good places your way but the ones I preferred in the past have closed down or been sold on to others.
If I had to do it again, Id do the sneaky stroker A12again that great torque from down low and went better than my fresh stock A14 before it (both used the head, stock cams, exhaust system, elec dizzie and inlet with same carb settings) but got a canary so hence went to the SSA12.
Prob suits a turbo better than stock a12 or A14 I feel as the pistons travel faster away from tdc due to short rods reducing the rod stroke ratios that could reduce detonation. However maybe the lighter rods and pistons play their role on the overall feel of the acceleration vs A14 etc etc.
|
|