|
Re: Wanted - 1 x used standard A15 piston (sample for forging supplier) | Subject: Re: Wanted - 1 x used standard A15 piston (sample for forging supplier) by D on 2019/1/19 2:29:13
Im not sure thats his problem though, but its even better if bores are thin to re-sleeve for the 80mm then grout the bottom end. Sleeving is around 450-650 with hone then grouting can be done at home up to the welsh plugs. These forgies are suitable depending on compression needs eg. low comp (small chamber head) https://www.ebay.com/itm/POLARIS-800-R ... 5hYeO82:rk:8:pf:0&vxp=mtr
higher comp (A14 crank/rods but A15 crank will need deck reclamation process to raise the deck 1 or 2mm before sleeving. A common on industrial and defunct engine blocks) https://www.ebay.com/itm/Wiseco-Forged ... :1&vxp=mtr&frcectupt=true
|
|