|
tacho installation | Subject: tacho installation by ddgonzal on 2019/2/1 23:58:06
For B110 (early 1200) this is how the tachometer goes into the dash
* Red/green wires are for the lights. Plugs into cluster * Black wire is earth/ground. Plugs into cluster * Yellow/red wire is Power. Plugs into cluster
* two Black/white wires are IGN signal. Plugs into the dash harness
Cars without tachometer have the wiring in place (utes do not have this). This is a BW wire along the top of the instrument cluster, usually with a bit of blue or yellow tape covering it
Pull the dash harness wires apart at the connectors, and plug them into the BW wires of the tachometer
|
|