|
Re: 60A bell housing bolts | Subject: Re: 60A bell housing bolts by TexasMidget on 2019/3/27 3:10:23
Thanks DD. Need more help on this. I found an old thread that you had on this same subject and you made a nice sketch. Are there any markings on the bolt heads that would help me sort them out? With regard to the long bolts, I have more of the 65mm than I do of the 60mm which appear to be the correct ones? I wouldn't think there would be a problem to use the 65mm. I have 3 setups, 2 are A15/60A 5-speed and 1- A12/56 4-speed all of which use the 3.5mm plate. I am sorting the bolts for the A15/5 speed.
Can't seem to find the correct starter bolts. There are a pair of identical bolts in one of the pics about 35mm but are not the proper thread for the starter. Any way you can tell if the bolts I have posted belong with the housing?
Older thread............
HOLES Blue: 8.5 mm Red (dowels): 9.5 mm Green: 8.5 mm Gray: 11 mm (bottom two are 10x11 oval)
BOLTS Blue & green (6) * 08120-06065 4-speed, 08120-06010 5-speed ** hex bolt medium-strength, M08(?) x 60mm long (6) Gray Starter * 08121-03533 BOLT-HEX W/WASHER(M10 X 1.5) (2) ** medium-strength M10 x 35mm long (2) Gray bottom right * 08111-02062 BOLT-HEX HEAD WITH WASHER, COVER TO TRA ** M10 x 20mm low-strength Gray GUSSET Engine-to-gearbox * left side, bottom two holes (fits in from front) ** 08131-04010 56-series high-strength M10 x 40mm ** 08131-03010 60-series high-strength M10 x 30mm
|
|