|
|
| Hotspark collar won't get past section of dizzie shaft |
Subject: Hotspark collar won't get past section of dizzie shaft
by TobeShaw on 2019/4/16 14:09:06
Hi there, I have a B211 with a Hitachi D4A5 (22100-H8301) and I am trying to install a hotspark ignition conversion but can't get the hotspark magnetic collar past an 18.2mm collar on the dizzie shaft. I attach a pic of the offending item. I'm also baffled by the 3 posts on my ballast resistor and the fact that the gap for the wires in the dizzie is way bigger than the replacement rubber insert that hotspark supply but I can silicon my way out of that one.
|
|
