|
Re: Hotspark collar won't get past section of dizzie shaft | Subject: Re: Hotspark collar won't get past section of dizzie shaft by ddgonzal on 2019/4/17 7:46:44
Quote:can't get the hotspark magnetic collar past an 18.2mm collar on the dizzie shaft Found this on the Hot-Spark USA site (didn't see it on the EU site): "kit's magnet sleeve fits distributor shaft lobes that measure 16.10 mm from flat edge-to-flat edge. A few Hitachi distributor shafts have a round extrusion or "bump," above the distributor shaft lobes, that prevents the magnet sleeve from being seated. In that case, you'll need to request a custom magnet sleeve that has the center hole enlarged"
|
|