|
|
| Re: casting 3D printed intake manifolds |
Subject: Re: casting 3D printed intake manifolds
by smellsofbikes on 2019/10/30 1:55:02
I'd love to have longer runners on the intake, but there simply isn't anywhere to put them. I thought about doing something similar to the BMW 2002tii setup, with intake runners that sweep up 90 degrees, then bolt to a manifold of runners that go over the top of the valve cover and put the fuel system on the other side of the engine. I'd love that, as I have a lot of room over there and could some day fit a supercharger under it. But to get the airflow in the space I have, I'd need to cast elliptical tubes only about 22mm high and really wide. I'm still thinking about it. But mild supercharging and fuel injection seems to be a lot easier.
|
|
