|
|
| Re: DOHC Front adapter plates |
Subject: Re: DOHC Front adapter plates
by Mattndew76 on 2020/1/26 0:06:58
I'm needing to save a few pennies myself just to buy the idlers and missing bits to get everything laid out correct.
I'm also looking at doing the timing plate with as little material waist as possible. 266.7mm x 266.7mm x 38.1mm billet blocks are a little expensive.
So far the only crucial part to the plate is the crank seal bore location and mating oil pan surface. Get all that correct and the upper half is peaches.
|
|
