|
Re: DOHC Front adapter plates | Subject: Re: DOHC Front adapter plates by Mattndew76 on 2020/1/11 8:57:30
If that is the current layout then no need to move anything.
I I don’t want to go any thinner than 3.5mm on the water passage wall. Looks like there is enough material there to make a decent water passage and leave a sturdy wall too.
Gotta check my paypal but I might have a few coin rattling around to buy some idlers, and a belt. I think I already have the Mazda HTD crank pulley, and might need to machine a cam pulley.
|
|