|
|
| Re: DOHC Front adapter plates |
Subject: Re: DOHC Front adapter plates
by Mattndew76 on 2020/2/17 18:14:32
Reuby can you send me a pilot email to Mattndew02@yahoo.com, and Ill send my plate model over. Its all in imperial measurements now though.
D all the pacers can be machined from aluminum instead of steel if they are good slip fits and aren't clanging around. Heck even the the crank drive pulleys can done from aluminum and they would be fine.
I will finish machining up the oil pan skirt, but I have to move back into manufacturing for a while. taking the days to get this going takes a toll on the income. R&D is always a losing battle in a garage based company.
|
|
