|
Re: DOHC Front adapter plates | Subject: Re: DOHC Front adapter plates by reuby_tuesday on 2020/2/19 4:53:22
Quote: D wrote: Could you know what the crank spacer is made from? steel pipe?
The sleeve that sits on the datsun crank to push the Mazda pulley out is just steel. I think it was machined from some bar, but some suitable pipe would work also. Now that I think about it, it should prob have a grub screw on it to hold it firm on the crank. It really just sits on there and it held in place y the crank bolt that holds the pulley on as well.
When I get home again, I can put the verniers on this and give you some measurements so that it can be added to the drawing repository.
|
|