|
|
| Re: A14 exhaust: where would you put an oxygen sensor? Also wow the back nut is a bear |
Subject: Re: A14 exhaust: where would you put an oxygen sensor? Also wow the back nut is a bear
by smellsofbikes on 2021/1/17 18:13:10
Yeah, I'm looking at just below the joint. (But low enough I can get the clamping collar for the joint down past the screws, obviously.)
I'll look for a copper seal/gasket: I hadn't yet found one available.
Zigmondo: there is room above the gasket but I have a cast iron header. (Haven't yet made my own.) That'd be a perfect place to put it but I can't weld cast iron. I've brazed steel to cast iron before but this definitely needs to be airtight, and I'm not confident of my ability to manage that.
Thanks!
|
|
