|
|
| Flywheels & clutch functionality |
Subject: Flywheels & clutch functionality
by edp on 2021/11/8 17:11:49
Im installing the new A12 engine to replace the A15 and the flywheel I had set aside and refaced turns out to be 35mm thick, the one I was running on the A15 was 28mm, apparently a A12 FW, also ran a engine plate 3.25mm & a standard ht bearing carrier 33mm, it had a problem with clutch disengagement so made a longer slave push rod, still never worked right. All coupled to a 60A 5 spd.
I had a brand new Exedy clutch & cover- man, it was hard to push! Planning on running the 28mm FW, standard carrier & no engine plate, sound right for proper clutch operation?
Wiki doesnt say anything about A15 FW's, were they 35mm thick?
man I hate posting pic's on this site, copied links from Icloud, didn't work. Wouldn't it be easier to be able to pull them direct from our computers or ph's and not have to off site host them....my rant
|
|
