|
|
| Needed ... Ca clutch and pressure plate |
Subject: Needed ... Ca clutch and pressure plate
by CA_1200_project on 2012/10/23 10:00:17
I am in the process of engineering a 1200/ca ute.
Story goes like this..
I have a hot motor getting built, new turbo, new clutch and a wolf 3d to run it all (may go stinger ems yet)
I also have a standard engine, box and turbo so il be installing these to get the road tests and all signed off while it's in under coat with all the emitions gear as needed. After I have the papers it will be stripped out to get paint/ pannel done and all the new running gear will go back in it along with a watts/4 link rear.
So that's the low down but to bolt this gear I'm in need of a clutch and pressure plate in drivable condition to get the handling and brake test out of the way.
Can anyone help me out??? Whether I rent/buy/lend I'm shore we can figure it out.
I'm in Melbourne but let me know if you can help
Thanks Rhys
|
|
