|
|
| Re: B310 SGX-E Wagon build |
Subject: Re: B310 SGX-E Wagon build
by AFRacer on 2017/5/27 14:04:03
Been a while on the updates; still just collecting parts. The NISMO front sway bar was installed last week, huge difference in the handling department. Need to install the 1" rear bar next and start taking corners uncomfortably fast. I finally acquired a set of correct fender mirrors, they are manual ones cause I couldn't find the full electric setup. I got a Sunny center console and new shift boots; lots of 720 parts are the same I'm finding out. The blower motor resistor is the same so now my heater works on low and medium speed finally too. I got and installed Sunny rear quarter emblems which popped directly into the original trim holes perfectly. I also scraped off some stupid Bernie Sanders stickers I had already defaced, and replaced with a nice JAF decal. I've actually got a decent amount of awesome stickers I never used from Matsuoka and Watanabe and more that I might eventually tag on it, we'll see. I bought a couple really awesome uncut old Sunny keys that I hope will work on either of my cars cause they are awesome! I have Cusco heavy duty engine mounts enroute to handle the extra power of it will eventually have. Also have another A series thermostatic clutch fan coming, but for my brother's 1200 that has some overheating issues. Couldn't believe how hard it was to find but it was only on factory a/c cars, and I think only B310s. Requires the matching water pump and pulley too which were easy to find. Only a few more months from bringing my wagon home though! I drove it all last week when I went to Washington for work and I'll hopefully get to drive it some more next week and I can change the oil. I think one of the rear wheel bearings might be getting worn though as it gets some brake squeal when cornering. Hopefully that can wait until fall. I'll get new pics up when I can!
|
|
