User Login    
 + Register
  • Main navigation
Login
Username:

Password:


Lost Password?

Register now!
Fast Search
Slow Search
Google Ad


Report message:*
 

Re: My CA18 Datsun 1200

Subject: Re: My CA18 Datsun 1200
by bezman on 2010/5/3 16:07:10

updates :)

I have been working on the car on and off over the last few weeks..

I swapped out the idle arm on the steering along with all the bushings and greased up everything pretty good, I still need an alignment badly. As far as the brakes go, I have decided to do the B310 front end swap (front control arm, tension rod, spindle and shock/springs) will then swap on some P11 front disks and R32 28mm Aluminum Caliper.

I have takens some time and cleaned up the engine bay wiring loom as it was a complete mess before :P
Funny thing when you buy old cars from country people, they have the most innovative ways of doing things.. everything from the wastegate to the seat belts on this car was tied down with wire. even the fuel pump, filter and regulator :)

I have gone through and bolted down everything that I could have and removed things that were not needed.. here are some photos of whats been going on..