|
Re: 2L 1200 Ute | Subject: Re: 2L 1200 Ute by blue_devil on 2016/3/26 9:34:50
Once the rears where done i could start looking at the front..
The first step was to set up the Headlights, Which included a big hole saw !!
With those holes done i could fit all the panels up. Straight away there was a major issue with the bonnet because the 4G63 is so tall the rover cover hit the bonnet so a lot of it needed to be cut out and re-glassed !! major pain...
One tip i can give when using Polyester resin is to take it back and get vinyl ester resin. The polyester resin pulled back way to much even if i backed off the catalyst. Making a few spots in the bonnet that needed to be fixed, Lesson learnt!!
|
|