|
|
| Re: Elrich11's CA18DET 1200 Ute |
Subject: Re: Elrich11's CA18DET 1200 Ute
by Elrich11 on 2015/1/17 10:09:13
Quote:
___1200ute wrote:
I have an s13 setup in my ute. I'm using S12 LCAs but had to section about 25mm out of each one to get the track back within the requirements. I section the area between the ball joint and the castor rod mount. The engineer I'm using for the design code (Ls3) is happy with this.
I was thinking about cutting the LCA from the treaded body section as it would be a simple mod, but the ball joint angle may be a problem. Your method is better to keep the ball joint angle reasonable. I also have a few sets of standard S13 LCAs which I can fool around with if I can engineer it.
|
|
