|
|
| Re: Weber DCOE EFI Throttle body |
Subject: Re: Weber DCOE EFI Throttle body
by lamb_daiquiri on 2020/3/22 20:41:50
I was planning on doing turbo and ITBs but the MSII ECU I have can't do it. I needed to use a mixed speed density/ alphaN (throttle position, engine speed) tuning method since the manifold vacuum is not useful above a certain throttle position with ITBs. AlphaN doesn't work with boost. If I could have an AlphaN region in the load table rather than a switch point line it may have been possible.
Short answer is check whatever ECU you're using can support ITBs and boost. The tuning may be a little tricky.
|
|
