cant come, working away that weekend. NOT HAPPY JAN! next time hey

hey Jarrad, a guy named stan from Allstreet tyres and wheels made them for me. He does custom metal fabrication on the side.
Jared

one step closer to completion.... my panels for the ute were delivered yesterday. i had the panel that runs from the back of the door to the tailights made up, the whole thing. I mentioned to the guy i was in the club and asked would he make more. He said he might... was only $350 for both sides. bargain!

checker plate would be heaps noisy. just go to midalia and buy some sheet metal and weld the sucker in where u need it. not too thick or you wont bend it. this is usually what happens with rusted out floor pans from my experience.

how you figure that out? cause that sounds about right but im obviously doing something wrong.

i believe the rocker rover will interchange as well as water pumps. Apart from that i dunno

would a bore of 3mm really make a difference? I was talking to someone who said a bore of 3mm would make it a 1500.45cc motor... is this correct? If it is, it barely sounds worth the trouble

Thanks! 3mm it is!

has anyone ever test bored an A15? cause i cant afford a test one and i dun wanna just bore out 40thou. so.. anybody? i wanna take it to the max!

when you take of the wheel there is a little metal "M" shaped thing on the left hand side. This is bent so that every time the wheel lug thingys make contact they push down and cancel the indicators. try bending it again ever so slightly cause from my experiences they are a bit brittle. sorry for the lack of technical term but hey im not wheel fixy guy.