Genuine Weber 32/36 carburetor for sale

Currently taken apart and ultrasonic cleaned ready for rebuild.

Complete rebuild kit including accelerator pump and bearing upgrades for throttle shafts plus a kit to convert the worn water choke for an electronic choke.

All new jets purchased.

$150

A12 parts for sale

Near new carb - $70
Inlet manifold - $50
Exhaust manifold - $50
Head + Gasket Set - $120
Alternator - $40
Starter - $40
Rocker Cover - $40
Near new fuel pump - $35

Block
Head
Conrods
Pistons


Anything else just ask!

Located in Sydney but happy to post anywhere and/or liaise with couriers

Nissan Datsun a12 engine

Thanks David! I guess the main thing will be a good tune and ECU.. With the turbo oil return do you have any pics of.someone who has done that?

So would there be anything in setting up the a15 I could do to help prepare it to run a turbo.application? Seeing as it's back from the engine builder after being.cleaned up and inspected

I was currently building up an a15 carb-based (eventually efi engine) - still need to order some bits so can swap it out to suit turbo application

I now have the opportunity to buy an oval port efi turbo setup.. just wondering if it would be better suited on the a15 or a12 with some mods?

it's a t2 turbo

Just wondering if this is the same part as the et turbo cas? The main part number appaears to be the same eBay http://www.ebay.de/itm/272476329415

Would you recommend running this or a Weber 32/36 on a smooth mild daily?

So would there be any changes needed to it to get it spec'd right for an a15 and what do you usually do about servicing the vacuum secondary?

Thanks David always appreciate your help

Hi further to a previous conversation on here I was hoping to help get an ID on a carb. I'm after the specific model number if possible as I'd like to give it a once over and would prefer I had a rebuild kit in the garage for it.
































Thanks very much

I can't seem to find a model number or markings on the carb to order a rebuild kit? I'd love to redo the gaskets etc.