Yea I mean the plastic plug, sorry. And the headlamp is a sealed beam unit. Is there any chance of fixing it by soldering the prongs back onto the unit or is it not worth it?

So I pulled the relay behind the headlamp off and 2 out of the 3 brass prongs came off with it....is that not supposed to happen? How do I fix?

Anyone know to replace the R/H door window? I have a replacement window ready to go in from the wreckers.

Attach file:

---

  DSC00662b.jpg (107.13 KB)

Anyone know a good Datsun electrician? My 1200 ute has a bunch of electrical issues and I was wondering if anyone knew a good contact on the Gold Coast?....preferably a mobile mechanic since I don't have rego or rwc for my ute yet.

Status update:

1) Installed new battery terminals this morning. Bought a battery charger and multimeter. Battery is now at full charge and the ute starts every time perfectly fine. Measured a constant 13.75 volts when engine is running and lights/radio are on. I am assuming the alternator is fine. Don't know the cause of the battery drain still.

2) Driver's headlamp still rooted on both low and high beam. Sprayed the connections with WD40 no help. I have a feeling that the headlamp is fine, is there any way to test it manually?

3) Driver's side indicator now working.

4) Radiator overflow tank installed.

5) Window winder still broke but I believe someone is donating one to me.

6) Wiper blades installed, had to cut ones down that I bought for local auto store.

7) Jacked the ute up and had a look at the gearbox. I believe I found the wires to the reverse lights and they tested live with my test light. There is two wires going into a box, wondering if the switch is rooted or perhaps the wires were previously hooked up incorrectly?

8) The license plate light is a mystery. I tested the bulb receptable with the test light and it is live. I pulled the old bulb out and replaced it with a new one but its still not working....grrrrr.

9) Dash lights still out. I can't seem to get the dash fascia to come off. There is only one screw left to take out I believe and its the one directly above the steering wheel up against the windscreen. I can't get a screwdriver in to loosen it since there is so little space. Any suggestions?

10) Driver's door lock still rooted, don't know why. I pulled the door lining off and had a look inside but I can't find the cause of the problem. Every time I manually pull down the lock from inside the door panel it seems to catch on something, can't figure it out.

Can't wait to get my ute on the road!!!

Need a replacement window winder for passenger window on my 1200 ute. Anyone selling a spare?

Thanks for the replies everyone. I am from the gold coast..coomera. Never worked on anything electrical before so I am a bit scared. Hoping a friend of a friend will come over to check the battery with a multimeter and use a tester on the other items not working. As for the gearbox, it was previously replaced with a 5 spd on the floor and from reading your comments I am pretty sure they didn't connect the reverse lights when they did the job. Is it difficult to check? Also how can you remove just the fascia of the dash and not the whole thing? Online guides that I have found so far only show how to remove the whole thing. Checked the window winder and it needs replacing...anyone willing to sell a spare? Also I checked the drivers door it seems to be loose at the hinge. I tightened the nuts all the way but it seems to have no effect. I am able to lift the door about 10mm - 15mm upwards. I am thinking that this is affecting the door lock as the locks only seem to operate on this particular ute when the doors are fully closed?

I proudly bought a 1976 Datsun b120 ute about 2 weeks ago. I've never owned a classic car before but always wanted to...so I am quite new to this whole thing. I am not mechanically inclined at all but I intend to learn. So far I have done major repairs to the body work where there was rust and I've replaced the battery. The car seems to run fine but it has some slight problems. I am too anxious to get it on the road but I am worried that it won't pass roadworthy. Would rather try and do the work myself than take it to a mechanic and pay loads of money. Just looking for some help from the experts and wondering if anyone has encountered these problems before:

1) New battery will not hold charge (I've replaced the old one because it did the same)
2) Driver's side headlamp is out but works when I fiddle with the 3-prong connector
3) Driver's side indicator will cut out randomly
4) I notice after the engine runs awhile there is a slight leak at the top of the radiator...seems to be because the hose is pinched under the cap?
5) Passenger window winder is broken...assuming I can get one from the wreckers?
6) Wiper blades need replacing...does a normal auto store carry these?
7) Reverse lights do not work, replaced all the bulbs still don't work
8) License plate light doesn't work, checked bulb and it appears fine
9) Dash lights for tachometer and speedometer not working...don't know if its the bulbs or wiring....I've checked the fuses under the dash and they are all intact. Too afraid to remove dash.
10) Driver's door lock doesn't seem to work but I noticed that driver's door doesn't fully close, is this why?
11) Noise coming from rear wheels when I drive it, could be wheel bearings?
12) Interior dome light doesn't seem to have an auto function...it's either on or off

Maybe I'll post some pictures of it soon. Thanks.