+1 for banning the &*^% ...

How many Moderators are there on this site? I know with another forum im a member of there are about 3 or 4 Mods and they are always "cleaning up" ... Im sure a few wont mind putting in some time just making sure everything is in order ...

Like a casino on wheels ...

Ok im going to give cleaning and sealing it a shot without removing it ...

Do i need to seal only between the glass and the rubber or between the rubber and the body as well?

Hamza

Sorry dd ... Its a B10 1k

The car only had a single speed switch when i got it, but i not have my hands on a 2 speed switch which i'd like to use, but i have no idea how ...

There are 4 wires coming from the switch (all red) & 4 wires from the motor (2 being used at the moment, 1 to the switch (+) and the other ground (-) so i know what those two are) ... How do i test which / what the wires from the switch are? And where do they go?

I've had a look at the Wiper wiring link in the tech wiki and it gives an idea on testing the motor, but what about the switch ...

So confused :S

Hamza

quite easy ... I think i cut a sheet in 2 and did the inside of the door that way ... You'll need more than 2 boxes for sure ... I've used 2 boxes so far and i've done all the interior except the firewall, none of the roof and nothing in the boot ... I'd say 3 boxes should cover the lot though (the boot will take 1/2 - 3/4 of a box easy) ...

I dont like my chances of find one of those ... :S

I think the back ones leaking too ... there was a puddle under the drivers seat (lucky i've take out the carpet)

Any tips on how to take it out?

Ill give it a shot to save some $, but if im going to risk breaking the glass then i'd rather pay the $ and get it done properly ...

I dont think the gain's would come near out weighing the loss in respect ...

Anyone?