Actually bit worried about the angle the motor might end up on.

The rotors centre rotation point is much higher than I anticipated and even with the gear box as high as I can get it and the sump literally on the steering rack its still on a fair angle.

Only solution I can see would be to raise the rear of the car.

I know the uni joints would wear quicker but what other issues will this cause?
Oil flow should be OK but I'm no rotor expert.

Floors cut, lotsa stuff done, #OOPS#loads to do yet. Pics soon

Am hoping to just weld the stock ute one for now. Kinda a zero dollar budget for this project so nothing spent unless its defiantly needed or I've broken it.

Been a while, had a third girl 3 weeks ago. Been driving Oot daily and starting to get some skill with it on the dirt.

Not sure if I've mentioned before but a friend has donated a 13b powered rx7 s2 for my disposal. I got it running nice so engine and box are out of it now. As is exhaust and soon wiring and fuel system. Ordered a new clutch slave and master as old ones were rusted shut.

Just need the inspiration and money for a custom tail shaft then I can start pulling Oot apart and welding up some bits.

A good friend has offered to bend me up a trans tunnel and can get hold of cheap metal for mounts so seems like its gonna happen.

For now I'll just work out as much of the wiring as I can and map out radiator and engine mounts.

Is that Rupee? Because AUD is $1600 if so...

Wouldn't a 304 still be good for ya. 316 is for by the sea side. Although I suppose better is best.

Just a price for now thanks. Didn't get your PM?

Cheers

Any cheap ute pairs?

Was going to wait until I've got the 13b in and running so I could sell both my A12's at the same time but need money to get tail shaft and metal for conversion.

Its a little smokey but only valve stem seals, have a new set in my glove box if ya want them with engine.

Carby has slight leak from accelerator pump. I nicked a section of the water inlet pipe but still useable just wont have a spot for heater hose. Came from a 1985 ute. Had done 160,000km's.

$100 please

Cheers,
Daniel

Killer