it got a Test Pressure Up To 10 PSI / Test Vacuum Up To 28" HG

is this okay??
thanks

hi does any one know if this vacuum guage will work to measure manifold pressure?

Attach file:

---

  guage1.jpg (95.54 KB)


  guage2.jpg (99.37 KB)

hi thanks i got it to isle at 800rpm and in drive its okay just a bit shaky but otherwise its okay!

but my choke still dosnt work i even tried leaning it still no response this problem started since i rebuilt the engine!

thank you
will try tommorow just stil dont no what to do about the choke not working!

damn i thought screwing the mixture in will rich and out will lean so its the opposite??

also my choke dosnt work at all when engine cold even if half way open just sputters and dies could this be if the mixture is to lean??

thanks!

which way does it lean and rich turning the screw my rpms are above 1000pm at idle coz once it goes to 900 it starts shaking bad in drive let alone 700 at idle would shake the hell out of me in drive!

dont know if its some problem or what i checked all the vaccum hoses and seem fine!

anyone no???

hi i had a problem in my carby that the mixture screw wasnt doing anything i finnaly fixed it it was just the adjuster inside on the accelarator was screwwed in too much what caused the carby to bypass the idle circuit!

anyways got that fixed now im trying to tune it i get good idle but when put in drive in shakes a bit and is gutless WOT until it picks up a bit! the micture scres about 2 and half turns out!

does this sound normal at WOT any more tips on how to tune??

Thanks!

mate what compression are those piston?

thanks!

yer tru unless ones just a remake and not registered?