Just a note with the loom...it was done by kev rowley to suite a standard ecu. I have a vipec now and the loom was cut from the main engine control fuses..

Hi Everyone,
I have left over stuff from ca18 conversion..

- OEM Heater Unit
- Thermo Switch for fans..brand new
- OEM Brake master cylinder
- Hydraulic clutch master and slave
- Manual Boost Tee
- CA18det Manual ECU with Loom
- Brake Pedal
- Oil Pressure Gauge - analouge
- CA18 AFM
- GTR Injectors x4
- 2x12v hairdryers
- Oil gauge sandwich plate.

Also EOI on my ca18det spare engine and dr30 gearbox (needs rebuild). Ran fine, compression good. Would suite a freshen up. I ended up with a forged setup.

Im located in Cairns. Make an offer on anything. Can use aus post, sendle or e-go.

http://i1167.photobucket.com/albums/q ... 33CB963EE_zps88rxknai.jpg


Got her back today..dyno sheet above.

Hey,

Been a hell of ride but the ute is due for pickup end of this week.....waaaay over budget.
New motor freshened up with cosmetic head gasket and vipec in. Fuel pressure reg, brake proportioning valve and heater unit installed. Lsd in and a good tidy up.
Can't wait to drive her!

A little bit of an update:

So I got my hands on a built/forged ca18det. A vipec ecu and my 1200 coilovers are in.
I have had to drop the car at workshop in cairns as work has just increased tenfold. They will do a couple of rust repairs and finish off a few little things for engineering.
pics to come

z32 and coils please

Hey,
have pm you

That's horrid. Poor Datsun

Pm or msg me. 0459346009

Chasing headrests for 1200 ute seats. Fair to good condition.