coolant leaking out between gear box and engine

I have same problem(a15 though) but there is oil mixed in. Was thinkin it could be gearbox main bearing.

Only leaks 50-100mls of each when parked.

Cheers for the valuable info/knowledge. I'll take some time off work soon and give it a crack.

Music to my ears!

thanks cadet1200

Its the panel from door to tail light corner panel.
I want to know if anyone has attempted this themselves and has any helpful hints/feedback.
So far this is all the info I have;
I need to drill the spot welds off the upper outer side. What about inside the door frame and the bottom of the panel?
Remove the panel with a chisel (and /or grinder) between the inner and outer.
Clamp new panel in position and weld. Mig welder? What is the smallest amp mig up for the job?

Any extra info or comments very welcome. Cheers

Where are you located?

Space the wheel that is too far under the guard

2) Unidentified wires not in wiring diagram - near clutch cable inlet - Yellow/red and Black wires

Mine are not connected either.

[i]3) Black wire near #2 spark plug in photo... says "to distributor" ?(Number 16 in diagram) Connects to what?
You should have a connection at the back of your distributor coming from the seam between the cap and the metal body.

Not sure of the others. Thats all I know

Is it necessary to cut standard 1200 strut or slip over original ones and weld? 45mm on inside of sleeve should slip over right?

Do you have photos of this. I am curious too. Where is it mounted?

Drive it, don't sell it. Ute day is every day